GE LOGIQ E9 Service Manual page 432

GE
D 5573152-100, R
IRECTION
Table 8-97
Be careful not to pinch any of the cables when installing the Upper OP Panel/Touch Panel Assembly.
5. Install the four screws to the Back Cover
from behind.
6. Install the five OP Panel Knobs.
7.
NOTE: If replacing the Bezel, you need to
install the same color LOGIQ E9
Nameplate as originally installed
(nameplates are included in the Bezel
FRU).
Apply the LOGIQ E9 Nameplate:
Before applying the Nameplate, make sure
the surface is clean and free of debris.
Remove the adhesive liner.
Apply the Nameplate into the indentation at
the top of the Bezel.
Press firmly to ensure the Nameplate
adheres to the Bezel.
Remove the protective film.
8 - 148
. 2
EV
Upper OP Panel/Touch Panel Assembly installation (cont'd)
Steps
NOTICE
Section 8-6 - Replacing Top Console Parts
LOGIQ E9 S
Corresponding Graphic
Back Cover of the Upper OP Panel/Touch
Panel Assembly, Screws and Washers
M
ERVICE ANUAL