GE LOGIQ E9 Service Manual page 501

GE
D 5573152-100, R
IRECTION
Table 8-132 BEP installation
6.
NOTE: If you DO NOT reconnect the internal BEP cable to the Backplane, the system will power
up but WILL NOT scan or WILL LAUNCH into simulator mode.
7.
Insert the bottom lip of the BEP cover inside the base of the BEP.
8.
Connect the battery cable to PCN1 and the CB to PB cable to PCN2 on the CB. Make sure the
cable connectors are "locked" into place on the CB connections.
9.
MAKE SURE all cables are clear of the BEP Cover and tilt the top of the BEP cover toward the
BEP.
Be careful not to pinch any of the cables when installing the BEP cover.
10. Tighten and secure the thumb screws or screws at the top of the BEP cover, or the three screws
that attach the cover to the BEP.
11. Replace the Printer Tray at the top of the BEP.
Be sure the lip, on the underside of the bracket, hooks on the edge of the card rack, and the three
tabs insert into the slots on the top of the BEP frame. The lip "clamps" the card rack and BEP
together. This is a tight fit.
12. Lower the lower Column Cover. Make sure the Column Cover is behind the Printer Tray.
13. Position the Front Cover to engage the Column Cover stop tabs.
14. Latch the two latches that clamp the Printer Tray to the top of the BEP.
15. Slide the Black and White printer into the
Printer Tray and connect the cables to the
back of the printer. Or, re-install the Shear
Wave Capacitor Pack, if present. See:
8-11-9 "Shear Wave Capacitor Pack
replacement" on page
16. Tighten the Printer Tray wing nut to secure the printer.
17. Connect all cables at the top of the BEP and all I/O cables (see:
connectors - J5 PCIe to GFI2 is present on GFI Configuration" on page
18. Replace the covers.
19. Re-install Base Load and Application software.
20. Enter the system's TCPIP settings and Option strings.
. 2
EV
Steps
NOTICE
8-284.
Chapter 8 Replacement procedures
LOGIQ E9 S
Corresponding Graphic
Printer aligned with Printer Tray
Figure 8-57 "BEP6 cable
8-208).
M
ERVICE ANUAL
8 - 217