Board
Specification
Test Point
Adjustment Point
Input Signal
Mode
Tape
M.EQ
1. Place the unit in the 625 mode
2. Adjust VC1 so that the DC level is 0V ~ 0.1V DC.
6.3.3. Burst Sample Phase Adj.(525)
Board
Specification
Test Point
Adjustment Point
Input Signal
Mode
Tape
M.EQ
1. Place the unit in the 525 mode.
2. Adjust VR6 so that the sample pulse is located at center of the
burst signal as shown in figure.
6.3.4. Burst Sample Phase Adj. (625)
V_OUT (F6)
0Vdc ~ 0.1V
TP11 (B-2)
VC2 (B-1)
REF IN = BB (PAL)
EE, INT SG
Oscilloscope
V_OUT (F6)
TP8 (A-4), TP10 (B-4)
S/H PLS P, VR6 (A-3)
REF IN = BB (NTSC)
EE, INT SG
Oscilloscope
84