Panasonic DVC PRO Studio AJ-D950P Service Manual page 58

5.7.7. Supply and Take-up Reel Unit Replacement
(Removal of Supply and Take-up Reel Unit)
1. Remove the top panel.
2. Remove the front loading unit.
3. Remove the bottom panel.
4. Remove the connector P34 and P35 on the Mech. I/F board.
5. Rotate CW the Red Plastic Screw which is used for manual tape
eject and load the S1 Post to make the space for screw (C).
6. Confirm that the S and T brake solenoid iron core are released.
7. Push the M Stopper Solenoid to release the M Stopper.
8. Remove 4 Screws (C), (D) and (E).
9. The Reel Table is hooked with inner rail. Slightly lift the Reel Table
so that it does not touch the brake release arm. Then remove the
Reel Table.
Note:
Memorize the groove position of Reel Base which is inserted the pin of Drive Arm Unit. (The
position can remember by the attached grease.)
(Installation of Supply and Take-up Reel Unit)
1. Insert the outer rail at the new Reel Table.
2. Hook the Reel Table Unit at the inner rail. Then install a Reel Table
58