Section 5
Notes
B601
B601
Various
8.
Place the orange selection cursor on that block,
after which you want to repeat the program se-
quence.
9.
Press the VSK 2 "Repeat program".
In the input mask "Repetition" enter the name for the
start mark and the end mark, as well as the number
of repetitions.
Confirm your inputs by pressing the VSK 8 "Accept"
or abort with pressing the VSK 7 "Cancel".
A new sequential program block "Repetition MARK1
MARK2" is inserted into the work plan (alike the pic-
ture below).
10.
The program blocks embraced by the marks
(MARK1, MARK2) will be repeated as often as en-
tered in the "Number of repetitions" field.
Page 48
840D/828D SINUMERIK Operate