Siemens Sinumerik 840D Operating Turning page 178

Section 2
Notes
B518
B518
Basic operations
5
Chanel operation messages
Display of operation messages with symbols.
Display area Description
In case of conditions with this symbol a manual
operation is required.
Operation in case of the message "Stop":
After the fault remedy the machining program will
be continued after pressing "NC-Start".
Operation in case of the message "Wait":
After a successful acknowledgement of the fault
from the conditions listed below, the machining
program will be continued automatically.
In case of conditions with this symbol a manual
operation is not normally necessary.
Page 6
Stop: No NC-Ready
Stop: BAG-Ready (mode-of-operation group)
Stop: EMERGENCY-OFF activated
Stop: Alarm with Stop activated
Stop: M0/M1 activated
Stop: Block completed in single block mode
Stop: Cycle-Stop activated
Wait: Read-in release missing
Wait: Feed release missing
Wait: Axis release missing
Wait: Feed override > 0%
Stop: NC-block erroneous
Wait: for external NC-blocks
Wait: Spindle release missing
Wait: Axis feed rate is 0
Stop: No channel ready
Stop: SERUPRO has reached the search desti-
nation and the NCK has stopped. SERUPRO is
the abbreviation for „Search Run by Program
test" and represents a new kind of block search.
Wait: Remaining dwell in seconds or in spindle
revolutions
Wait: HiFu-acknowledgement missing
Wait: Defined position not attained
Wait: for positioning axis
840D/828D SINUMERIK Operate