Siemens Sinumerik 840D Operating Turning page 472

Hide thumbs Also See for Sinumerik 840D:

Complex programming example

Program the following G code commands:

N260 G96 S260 M4

Insert another "Stock removal 2" cycle into the pro-

Press the VSK 1 "Stock removal".

The work area for the technology "Stock removal"

Press the VSK 4 "Stock removal 2", to open the pa-

rameter mask for the "Stock removal 2" cycle ".

Insert the values into the parameter mask like dis-

played below:

Confirm your inputs by pressing the VSK 8 "Accept".

The following line is inserted into the program:

N270 CYCLE951(60,0,42,-25,42,-25,1,5,0.3,0.3,11,

3,0,3,1,0.3,1,2,1010000)

Program the following G code line:

N280 G0 X200 Z200

Insert a new tool (PLUNGECUTTER_3) into the pro-

Press the VSK 1.1 "Select tool".

The tool list window opens.

Mark the desired tool (PLUNGECUTTER_3) in the

tool list window with the orange selection cursor.

Press the VSK 1.1 "To program".

The following program line is inserted into the pro-

N290 T="PLUNGECUTTER_3"

Optional you can program the line by hand.

840D/828D SINUMERIK Operate

Sinumerik 828d