Set The Number Of Days Until The First Test Report; Change Domestic Phone Numbers - Bosch Solution 2000 Installation Manual

Control Panel
5.
7.1.4

Set the Number of Days until the First Test Report

This function determines when the system sends the first Test Report (Contact ID Event Code
602). If you do not use this Installer Code function, the first Test Report is sent to the base
station receiver after the repeat interval programmed in Location 434 (refer to Test Reporting
Time, page 112). If you want the system to send the first Test Report sooner than the repeat
interval, use this function to set when the first Test Report is sent.
To set the first Test Report:
1.
2.
7.1.5

Change Domestic Phone Numbers

When the system is set up for domestic dialing, this function allows the installer to view and
program the telephone numbers the system calls if an alarm occurs. Refer to Domestic Dialing,
page 79 for more information.
To change domestic phone numbers:
1.
2.
–
–
3.
4.
5.
Digit Required
0
1
2
3
4
5
6
7
Table 7.1: Domestic Dialing Telephone Digits
Bosch Security Systems, Inc.
Press menu [-] to exit.
Enter the Installer Code and press [1][AWAY]. Three beeps sound and the STAY and
AWAY indicators flash.
Enter the number of days (1 to 15) and press [AWAY]. Two beeps sound and the STAY
and AWAY indicators are extinguished. The system returns to the disarmed state.
Enter your passcode and press [2][AWAY]. Three beeps sound and the STAY and AWAY
indicators flash. There are 8 telephone number locations. Numbers 1 and 2 are for
receiver 1. Numbers 3 and 4 are for receiver 2. Numbers 5 and 6 are for receiver 3.
Numbers 7 and 8 are for receiver 4.
Press the sequence number to view and set/modify the corresponding telephone number.
If telephone numbers are programmed, they are displayed one digit at a time using the
remote codepad indicators. Refer to the table Domestic Dialing Digits below for the
indicators and their meanings.
If no telephone numbers are programmed, [15] is displayed and an additional two beeps
sound after entering this mode. These two beeps normally sound after you enter the last
digit of the last phone number.
Enter the digits for the phone number. Each digit is displayed as you enter it.
Press the [AWAY] to save and exit from this mode.
Repeat steps 1 - 4 to program another phone number.
Number to Program
0
1
2
3
4
5
6
7
Digit Required
8
9
*
#
4-sec Pause
Terminator
Installation Guide
System Functions | en 45
Number to Program
8
9
* 1
* 2
* 3
* 5
2017.10 | 03 | F.01U.298.026