Led 15: Change Verified Account Code; Led 14: Verified Account Code; Led 11: Dial Pulse - Dual-Tone Multi-Frequency (Dtmf) Off; Led 10: Change Disa Security Code - Toshiba Strata DK40 Programming Manual

System & Station

LED 15: Change Verified Account Code

With LED 15 ON, a station can change the Verified Account Codes established in
69. Selected stations must dial the following sequence to change the codes:
Press & button if your electronic telephone does not have a 5HGLDO button.
Total Account Code digit length is set in Program 60-4 (up to 15 digits). All digits do not
have to be verified.

LED 14: Verified Account Code

With LED 14 ON, the system verifies all Forced or Voluntary Account Codes
69) dialled by the station user. If the station user does not dial a specific Verified Account
Codes, the call does not execute (Forced), or the Account Code is not validated for the SMDR
call report (Voluntary).

LED 11: Dial Pulse - Dual-tone Multi-frequency (DTMF) OFF

If any device or TIE line (PEMU only) station port does not require the K5RCU for DTMF
decoding, it should be programmed for Dial Pulse (LED 11, ON). When the device goes off-
hook or the TIE line is seized for an incoming call, the K5RCU will not be accessed, (this
also can reduce potential traffic to the K5RCU).
Note

LED 10: Change DISA Security Code

When enabled (LED 10 ON), allows a selected station to change the DISA security code by
dialling [PDN] + &98;, + Security Code + 5HGLDO.

LED 09: Change Toll Restriction (TR) Override Code

When enabled (LED 09 ON), two TR Override codes are available. When one of these codes
is dialled from any station, all Toll Restriction is bypassed.
Change TR Override codes by pressing [PDN] + &987 for Code 1, or [PDN] + &988 for
Code 2. Press 5HGLDO to store.

LED 08: Forced Account Code

When enabled, (LED 08 ON), a station or Direct Inward System Access (DISA) Exchange
line user using a line with a Forced Account requirement (Program 15-7) must enter an
Account Code before the outgoing Exchange/tie/DDI line call can be completed. If Forced
Account Codes should be verified, enable Verified Account Code (LED 14 ON). The digit
length of Forced Account Codes is determined in Program 60-4.
3-62
[PDN] + &98< + Verified Account Code + 5HGLDO:
System
DK40
Toshiba strongly recommend that Dial Pulse is not set for two wire devices and
AC15 TIE Lines as this causes intermittent problems during the transfer of calls.
This should only be used for E & M TIE Line operation.
Program 30 Station Class of Service
Verified Account Code
000~299
Strata DK40 Programming Manual Spring 1999
Program
(set in Program