Makita 4101RH Instruction Manual page 12

1
2
1. Pressure regulator assembly
2. Pressure regulator
3. Adaptor
4. Vinyl tube
5. Water pipe
1
2
1. Wing bolt
2. Blade case
3. Water pipe
1
2
3
4
1. Faucet
2. Pressure regulator assembly
3. Water cock
4. Water pipe
12
Assemble the above parts hand tight as follows.
003535
1. Cut the vinyl tube at an angle for easier insertion. Push
the end of the vinyl tube into the end of the adaptor using
3
a combination pushing and twisting motion.
4
2. Screw the pressure regulator tight on a the adaptor.
3. Connect the vinyl tube firmly to the water pipe.
5
Installing water pipe
003536
First, unplug the tool. Loosen the wing bolt on the depth
guide and move the base down. Install the water pipe on the
blade case using the screw.
3
Screw the pressure regulator tight on a faucet.
003537
Adjust the amount of water flow by simply adjusting the water
cock.
CAUTION:
• Do not connect the adaptor directly to a faucet. If you do
so, the vinyl tube may come off the water pipe during
operation.