Advertisement
Reversing switch action
This tool has a reversing switch to change
the direction of rotation. Slide the revers-
ing switch to the right for clockwise rota-
tion or to the left for counterclockwise.
CAUTION
:
0
Always check the direction of rotation before operation.
Use the reversing switch only when the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may ruin the tool.
Speedchange
0-400
Rlmin.
Speed change knob
change knob so that the arrow of the de-
To change the tool speed, turn the speed
Adjusting fastening torque
The fastening torque can be adjusted in six
stages
by turning the adjusting ring so that
the pointer on the adjusting ring points to
a number on the tool body. The fastening
torque is minimum when the pointer
points to the number 1 and maximum
when it points to the
-8-
marking. The
clutch will slip
a t
varying torque levels
when the pointer is
set a t
the numbers 1 to
5. The clutch is designed not to slip
a t
the
-8-
marking.
Adjusting ring
Pointer
-
7
-
Before actual operation, drive a trial screw into your material or
a
piece of duplicate
material to determine which torque level is required for a particular application.
NOTE :
0
The adjusting ring cannot be locked with the pointer positioned half-way between the
.When using the tool
as a
drill (with optional accessory drill chuck installed), align the
numbers.
pointer with the
-8-
marking.
8
Advertisement
