Initially, adjust the locator assembly t o create a distance of approximately 1 mm
(3/64")
from the tip of the locator t o the base of the screw head. One full turn of the locator
equals
1.5
mm
(1/16")
change in depth. After adjusting the locator assembly, push the
locking sleeve in t o lock the locator in place. Drive a trial screw into your material or a
piece of duplicate material. If the depth i s not suitable for the screw, continue adjusting
until the proper depth setting i s obtained.
1
mm
(3/64")
--
Switch action
Tool speed i s increased by increasing pres-
sure on the trigger. To start the tool, simply
pull the trigger. Release the trigger
to
stop.
For continuous operation, pull the trigger
and then push in the lock button. To stop
the tool from the locked position, pull the
trigger fully, then release it.
1 mm
(3/64")
I t - -
r
<
Trigger switch
Lock button
CAUTION :
Before plugging in the tool, always check to see that the trigger switch actuates properly
and returns to the "OFF" position when released.
NOTE
:
Even with the switch on and motor running, the bit will not rotate until you
fit
the point
of the bit in the screw head and apply forward pressure to engage the clutch.
6