Removing or installing locator assembly
To
remove the locator assembly, pull the
locking sleeve forward and then turn it
counterclockwise.
To install the locator assembly, screw it
clockwise and then push the locking sleeve
back in lightly toward the motor. Turn the
locking sleeve slightly to match the locking
positions and then push in firmly to lock
the locator in place.
After removing the locator assembly, pull
firmly to remove the magnetic bit holder.
Hold the magnetic bit holder in your hand
and grasp the bit with a pair of pliers. Pull
the bit out of the magnetic bit holder.
Sometimes, i t helps t o wiggle the bit with
the pliers as you pull.
Locking sleeve-,
Locking position
'
Locator
Bit
I
Locator
\ I 1
Removing or installing b i t
CAUTION :
Always be sure that the tool i s switched off and unplugged before removing or installing
bit.
To install the bit, follow the removal procedures in reverse.
Depth adjustment
Pull the locking sleeve forward and then
turn it to adjust the depth.
Locking position
Gear housing
5