Makita HM1202 Instruction Manual page 10

1
1. Screwdriver
2. Brush holder cap
1. Screws
1
1. Socket wrench
2. Crank cap
1
1. Hammer grease
10
Use a screwdriver to remove the brush holder caps. Take out
002954
the worn carbon brushes, insert the new ones and secure
2
the brush holder caps.
Lubrication
002967
This tool requires no hourly or daily lubrication because it
has a grease-packed lubrication system. It should be relubri-
cated after every 6 months of operation. Send the complete
1
tool to Makita Authorized or Factory Service Center for this
lubrication service. However, if circumstances require that
you should lubricate it by yourself, proceed as follows.
Run the tool for several minutes to warm it up. Switch off and
unplug the tool.
Loosen the six screws and remove the handle.
002968
Remove the crank cap using a socket wrench. Rest the tool
on the table with the bit end pointing upwards. This will allow
2
the old grease to collect inside the crank housing.
Wipe out the old grease inside and replace with a fresh
002969
grease (30 g; 1 oz). Use only Makita genuine hammer
grease (optional accessory). Filling with more than the speci-
fied amount of grease (approx. 30 g; 1 oz) can cause faulty
hammering action or tool failure. Fill only with the specified
amount of grease.
Reinstall the crank cap and tighten with the socket wrench.
CAUTION:
• Do not tighten the crank cap excessively. It is made of
resin and is subject to breakage.
• Be careful not to damage the terminals or lead wires
especially when wiping out the old grease or installing
the handle.