Makita 6953 Instruction Manual page 7

ASSEMBLY
1
2
1. Socket
2. Anvil
1
1. Hook
2. Expand
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Selecting correct socket
Always use the correct size socket for bolts and nuts. An
incorrect size socket will result in inaccurate and inconsistent
fastening torque and/or damage to the bolt or nut.
Installing or removing socket
CAUTION:
• Always be sure that the tool is switched off and
unplugged before installing or removing the socket.
To install the socket, push it onto the anvil of the tool until it
001644
locks into place. To remove the socket, simply pull it off.
Hook
The hook is convenient for temporarily hanging the tool. This
can be removed without using a tool. This can be installed on
either side of the tool.
Installing and removing hook
Expand the upper part of the hook in both directions and
001645
remove it. To install the hook, follow the removal procedure in
reverse.
2
7