Advertisement
Installing or removing driver bit or drill bit
CAUTION :
Always be sure that the tool is switched off and the battery cartridge i s removed before
installing or removing the bit.
To install the bit, push the sleeve up to-
ward the "FREE" side and turn the sleeve
counterclockwise while holding the ring
with your other hand as illustrated a t right.
Place the bit in the chuck
as
far
as it
will
go. Hold the ring firmly and turn the sleeve
clockwise to tighten the chuck. Then push
the sleeve down toward the "LOCK' side.
See illustration.
I
FREE side
To remot
counterclockwise while holding the ring with your other hand.
the bit, push the sleeve up toward the "FREE' side and turn the sleeve
CAUTION :
0
Do not attempi to turn the sleeve forcibly when the sleeve is in the "LOCK" position.
The sleeve may be damaged.
.Always push the sleeve down toward the "LOCK' side before operation. If you operate
the tool with the sleeve in the "FREE" position, the chuck may loosen and the bit may
come out unexpectedly.
7
Advertisement
