Advertisement
Installing or removing battery cartridge
.Always switch off the tool before insertion or removal or the battery cartridge.
0
To remove the battery cartridge, pull out
the set plate on the tool and grasp both
sides of the cartridge while withdrawing it
from the tool.
0
To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip it into
place. Snap the
set
plate back into place.
Be sure t o close the set plate fully before
using the tool.
Battery cartridge
I
Do not use force when inserting the battery cartridge.
If the cartridge does not slide in easily,
it
i s not being inserted correctly.
Charging
Plug the fast charger into your power
source. Insert the battery cartridge so that
the plus and minus terminals on the bat-
tery cartridge are on the same sides as their
respective markings on the fast charger.
Insert the cartridge fully into the port
so
that it rests on the charger port floor.
Press the start button (red). The charging
light will come on and charging will begin.
If the charging light does not come on, press the reset button (yellow) first, then the start
button (red). If the charging light goes out within 10 seconds even after pressing the
reset button and s t a r t button a couple of times, the battery cartridge is dead. (CAUTION:
Wait for more than 5 seconds after the charging light goes out t o press the reset button
again.) Replace
it
with a new one. When the charging light goes out after about one our,
you may remove the fully charged battery cartridge.
After charging, unplug the charge from the power source.
CAUTION :
0Your new battery cartridge is not charged. You will need t o charge it before use.
* D o not keep the button pressed in with tape, etc. or the circuit will not function pro-
perly. Also, a malfunction of the charger may result possibly causing overheating, etc.
If you try t o charge a cartridge from a just-operated tool, sometimes the charging light
will not come on. If this occurs, l e t the cartridge cool off for
a
while. Then re-insert it
and try t o charge it once more.
When you charge a new battery cartridge or a battery cartridge which has not been used
for a long period, it may not accept a full charge. This i s a normal condition and does
not indicate
a
problem. You can recharge the battery cartridge fully after discharging
it almost completely a couple of times.
If you wish t o charge two battery cartridges, allow 15 minutes between chargings on the
fast charger.
Reset
button
6
Advertisement
