Removing The Cutting Unit - Husqvarna P 520D Operator's Manual

ASSEMBLING AND ADJUSTMENTS
Fitting the cutting head
- Combi 132 X, Combi 155 X
17 Follow the instructions for 'Assembling the Cutting Deck'
steps 1-16.
18 Pull the hydraulic hoses from the cutting deck through the
eyelet.
19 Connect the hydraulic hoses from the cutting deck to the
quick couplings on the machine.
20 Make sure hydraulic hoses are coupled correctly by
adjusting the cutting height with the cutting height control
on the machine. For more information, see 'Cutting Height
- Combi 132 X, Combi 155X'.
21 Select a function with the cutting height control (raise,
lower) with the location of the hydraulic hoses in the quick
couplings on the machine. Switch the raise and lowering
function by changing the location of the hydraulic hoses.

Removing the cutting unit

WARNING! Never leave the universal drive
!
shaft of the machine with one end loose. If
the engine is started, damage can occur.
1 Place the machine on a flat surface and apply the parking
brake.
2 Disconnect the hydraulic hoses from the quick
connections on the machine.
(Combi 132 X, Combi 155 X)
3 Raise the cutting unit halfway.
4 Turn off the motor.
5 Remove the lifting eyes from the cutting unit.
6 Start the engine and lower the cutting unit to the lowest
position. The cutting unit now hangs free at the back.
7 Turn off the motor.
8 Remove the service hatch.
9 Slide back the ring to release the quick connector and to
be able to pull the propeller shaft from the shaft journal.
Remove the universal drive shaft completely. Lift off the
lock chains.
10 Remove the pins from the shafts and remove the shafts
from the link joints.
WARNING! If the help function is connected,
!
the lift arms move with great force when the
pins are loosened. Observe caution to avoid
trapping your hand.
– 15
English