Adjusting The Cutting Height; Transport Position; Lever For Hydraulic Lift Of Attachments - Husqvarna P 520D Operator's Manual

Adjusting the cutting height

The cutting height can be adjusted to seven different
positions.
Select the required cutting height (1-7) using the cutting
height adjusters. Set the knobs horizontally so that they do
not snag on bushes and the like. For more information, see
'Cutting Height and Tilt Angle Adjustment'.

Lever for hydraulic lift of attachments

The lifting lever is used to put the cutting unit in either the
transport or mowing position when hydraulic pressure is
available.
The lever has four different positions.
1 Neutral position or transport position
2 Lowers the cutting unit with spring return to the neutral
position
3 Floating where the lever stops. The unit is lowered to the
automatically floating position, which means that the
cutting unit follows the contours of the ground.
4 Raises the cutting unit with spring return to neutral
position.
Mowing Position
• Lower the cutting unit by directly moving the lever forward
to the float position where the lever stays put. (3)
• Start the drive for the blades by pulling up the drive control
for the cutting unit.
20 –
English
OPERATING

Transport position

• Stop the blades by pressing in the control for driving the
cutting unit.
• Pull back on the lever for the hydraulic lift to engage
transport position. The unit is then raised. (1)
(P 525D)
When a steady speed is required, the catch for the forward
pedal can be pulled back with your foot. This will hold the
forward pedal in half-speed position (1) for controlled mowing
also on uneven lawns.
For more information, please see 'Speed Control'.
Braking
• Release the drive pedals. The machine slows and is
stopped by the drive system. Do not use the parking brake
as the drive brake.
• Quicker braking is possible if you press down the drive
pedal for the opposite direction.