Joint Bearing; Link Brace; Knobs For Setting The Cutting Height; Driver Seat - Husqvarna P 520D Operator's Manual

Joint bearing

• Grease the waist section of joint bearing Lubricate with a
grease gun until the grease is forced out.

Link brace

2 grease nipples, one on each side.
• Lubricate with a grease gun until the grease is forced out.

Knobs for setting the cutting height

• Lubricate front and rear knobs with oil.

Driver seat

• Fold up the seat.
• Lubricate the lever for longitudinal adjustment with oil.
• Lubricate the longitudinal adjustment runners with
grease. Pull the seat back and forth and lubricate on both
sides.
40 –
English
Lubrication

Lubricating the cables

• Remove the cable´s rubber casing when lubricating.
• Grease both ends of the cables and move the controls to
end stop positions when lubricating.
• Re-attach the rubber covers on the cables after
lubrication.
Cables with sheaths will jam if they are not lubricated
regularly. A jammed cable may cause malfunction, such as
the parking braking being applied. If a cable binds, remove
the cable and hang it vertically. Lubricate it with thin engine oil
until the oil begins to escape from the bottom.
A tip: Fill a small plastic bag with oil and tape it so that it seals
against the casing and allow the cable to hang vertically from
the bag overnight. If you do not succeed in lubricating the
cable, it must be replaced.
Throttle and choke cables, lever
bearings
• Remove the right side cover on the lever housing (3
screws) and open the engine cover.
• Lubricate the cables' free ends with the oilcan, even those
by the engine.
• Move the controls to the end points and lubricate again.
• Replace the lever housing's side cover.

Lubricate the parking brake wire

• Remove the rubber cover and lubricate the cable with oil.