Removing The Cutting Unit - Husqvarna Rider 100 series Workshop Manual

Removing the cutting unit

The cutting unit can be removed in order to
facilitate cleaning and servicing.
To remove the cutting unit proceed as follows:
1 Put the machine in a level position.
2 Apply and secure the parking brake.
3 Check that the lever for setting the cutting height
is in the S position.
4 Move the lifting lever to cutting position.
46 – English
5 Loosen the snap-in lock and lift off front cover.
6 Unhook the spring.
7 Lift off the drive belt.
8 Grab the upper pipe construction of the unit and
pull it out until it stops.
9 Make sure the equipment lock is in upright
position.
10 Loosen the stay from the cutting deck by
removing the pin.
11 Grab the upper pipe construction of the unit and
pull it out.
Repair instructions