Adjusting The Height On The Multiline Terminal; Removing Or Installing The Tilt Legs On The Multiline Terminal; Remove Tilt Legs - NEC Univerge SV9100 Hardware Manual

Issue 1.2
4.10
4.11
5 - 66

Adjusting the Height on the Multiline Terminal

The height of the DT series multiline terminals can be adjusted by moving the
legs attached to the bottom of the terminal.
1. Turn telephone over (button side down).
2. Adjust legs to desired height (refer to
DT700 Series Terminal).
Figure 5-58 Adjust Height of DT Series Terminal
3. Turn telephone over (button side up).

Removing or Installing the Tilt Legs on the Multiline Terminal

The Tilt Legs can be removed or installed on the DT Series multiline terminal.
4.11.1

Remove Tilt Legs

1. Place the telephone on a flat surface (button side down).
2. Separate the Tilt Legs and place them flat against the
Figure 5-55 Adjust Height of DT300/
Installing DT Series Digital and IP Multiline Terminals
UNIVERGE SV9100