Advertisement
R
epair
6) Assembling linear ball bearing 3064
1. In this bearing, slide pipe is held with
balls which is lined in 6 streaks.
Put linear ball bearing 3064 on
the hole of turn base.
When putting it, the balls
have to be located as illustrated
in Fig. 7A.
2. Put 1R033 "bearing setting plate" on the
linear ball bearing 3064, and slowly
press them with arbor press as
illustrated in Fig. 7B.
3. So, the linear ball bearing can be
assembled to turn base with protrusion
of approx. 3mm as illustrated in Fig. 7C.
7) Disassembling and assembling felt ring and cap
[ Disassembling ]
1. Hitch the inside of cap and pull it out of turn base.
The disassembled cap can not be reassembled
because of its deformation. It has to be replaced with
new one, when assembling.
[ Assembling ]
1. Apply enough oil to felt ring 30 before assembling, for smooth sliding of slide pipe.
And then, mount the felt ring 30 into cap as illustrated in Fig. 8.
2. Assemble cap together with felt ring 30 to turn base by pressing them with arbor press
as illustrated in Fig. 8.
Felt ring 30
Turn base
Linear ball
bearing 3064
Fig. 7A
1R 033 Bearing
Fig. 7B
Cap
Felt ring 30 (applied enough oil)
Turn base
Fig. 8
Cap
Fig. 7
setting plate
Approx.
3mm.
Fig. 7C
P 7 / 13
Advertisement
