Advertisement
R
epair
< 4 > Assembling motor section
1. Put blade case on the turn table of arbor press as
illustrated in Fig. 13A.
Put compression spring 28 and spring holder in
the blade case. And then, put steel ball 6.4 and
ball bearing 606 for jigs as illustrated in Fig. 13A.
2. And press them down with arbor press as
illustrated in Fig. 13B. Insert 2 pcs. of
round bars into the holes of blade case
for blocking compression spring 28
and spring holder.
3. Put the above motor section to arm of
base section, and pass pipe 16-90 through the holes
of arm and blade case as illustrated in Fig. 13C.
And assemble the motor section to arm by fastening
hex bolt M10 x 105 and hex lock nut M10.
< Note 1> Do not forget to assemble
flat washer 10.
< Note 2> Do not take off the round bars
which are inserted for blocking
compression spring 28
and spring holder, in this process.
Ball bearing 606
as a jig
Round bars for blocking
compression spring 28
and spring holder
Hex bolt M10 x 105
Steel ball 6.4
as a jig
Turn table of
arbor press
Compression
spring 28
Turn table of
arbor press
Flat washer 10
P 10 / 13
Spring
Fig. 13A
holder
Fig. 13B
Hex lock nut M10
Pipe 16-90
Fig. 13C
Advertisement
