Appendix E: Regulatory Information - Linksys PAP2T User Manual

Internet Phone Adapter with 2 Ports for Voice-over-IP
The telephone company may make changes in its facilities, equipment, operations, or procedures that could
affect the operation of the equipment. If this happens, the telephone company will provide advance notice in
order for you to make the necessary modifications in order to maintain uninterrupted service.
In the event this equipment should fail to operate properly, disconnect the unit from the telephone line. Try using
another FCC approved device in the same telephone jack. If the trouble persists, call the telephone company
repair service bureau. If the trouble does not persist and appears to be with this unit, disconnect the unit from
the telephone line and discontinue use of the unit until it is repaired. Please note that the telephone company
may ask that you disconnect the equipment from the telephone network until the problem has been corrected or
until you are sure that the equipment is not malfunctioning. The user must use the accessories and cables
supplied by the manufacturer to get optimum performance from the product.
No repairs may be done by the customer. If trouble is experienced with this equipment, please contact your
authorized support provider for repair and warranty information. If the trouble is causing harm to the telephone
network, the telephone company may request you remove the equipment from the network until the problem is
resolved. This equipment cannot be used on telephone company provided coin service. Connection to Party Line
Service is subject to state tariffs.
Safety Notices
Caution: To reduce the risk of fire, use only No.26 AWG or larger telecommunication line cord.
Do not use this product near water, for example, in a wet basement or near a swimming pool.
Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.
Industry Canada (Canada)
This device complies with Industry Canada ICES-003 rule.
Cet appareil est conforme à la norme NMB003 d'Industrie Canada.
IC Statement
Operation is subject to the following two conditions:
1. This device may not cause interference and
2. This device must accept any interference, including interference that may cause undesired operation of the
device.

Appendix E: Regulatory Information

27