Makita 2702X1 Instruction Manual page 23

How to perform rabbeting
1, Remove blade guard.
2. Attach auxiliary fence to rip fence for cuts that run the length of the stock. Facing
should be as high as the workpiece is wide. Adjust fence and blade to desired dimen-
sions.
3. First cut: Hold board flat on table as in ordinary ripping.
4. Second cut: Set workpiece on its edge.
(Use featherboards, push stick, push
block and so on, using precautions,
safety rules and guidelines for ripping or
related work.)
5.
For end-type rabbeting, if the workpiece
is less than 10-1/2" wide, rest the wood
flat on the table against the miter gauge
(with wood facing). The rip fence should
not be used.
6. After rabbeting is completed, immedi-
ately re-install the blade guard as before.
Rabbet
Table saw stand
(Part NO. 192680-7)
Place the stays on a level location and
assemble the legs inside. Secure with the
bolts
and nuts, then attach the rubber caps
to the ends of the legs.
Rubber cap
- b
Leg
Under stay
Now set the table saw on top of the
assembled stand and secure with four
bolts, washers and nuts.
NOTE: Models 2702x1 and 2703x1 are
standard-equipped with a table saw
stand.
23