Makita 2702X1 Instruction Manual page 11

CAUTION:
I
~
Scale plate
3
I
Arrow mark
Always grasp the striped portion of the
wrench when tightening the hex bolts. If
you tighten the hex bolts while grasping
the wrench further than the striped por-
tion, the hex bolts may be damaged
and/or an injury to your hand may result.
6. With the grip of the rip fence lowered, turn the adjusting nut clockwise to secure the
rear end of the rip fence. Do not turn the adjusting nut clockwise excessively. You may
have some difficulty adjusting the rip fence parallel with the saw blade when re-
positioning the rip fence.
CAUTION:
Be sure to adjust the rip fence parallel with the blade, or a dangerous kickback condition
may occur.
Bring the rip fence up flush against the side
of the blade. Make sure that the arrow
pointer on the fence holder points to the
0"
graduation. If the arrow pointer does not
point to the
0"
graduation, loosen the screw
on the scale plate and adjust the scale
plate.
Switch action
This tool is equipped with a special type of
switch to prevent unintentional starting. TO
start the tool, first depress the switch lever.
While keeping it depressed, pull its lower
portion toward you. To stop the tool, press
the lower portion of the switch lever.
Screw
7
I
4 -
Fence holder
Ylkl
- I
Swltch lever
l o 1
Key
-
11