Makita 2702X1 Instruction Manual page 19

ACCESSORIES
CAUTION
:
These accessories or attachments are recommended for use with your Makita tool speci-
fied in this manual. The use of any other accessories or attachments might present a risk
of injury to persons. The accessories or attachments should be used only in the proper and
intended manner.
Dado head set
P a r t
NO.
1915434)
A dado is cutting a rabbet or a
wide groove
into the workpiece. The dado head set con-
sists of two outside cutters, three inside
cutters and paper washers.
1
1/8" 118" 1/16" 1/8"
1/8"
Outside cutters : 6" diameter, 118'' thick,
Inside cutters
: 6" diameter, 118'' thick,
I
518" arbor hole, 2 pcs.
518" arbor hole, 2 PCS.
Inside cutter
Paper washers : 518'' arbor hole, 6 pcs.
: 6" diameter, 1/16" thick, 518'' arbor hole, 1 pc.
Various combinations of these cutters are used to cut grooves from 118'' to 112'' for use in
making joints, tenoning, grooving, etc.
Dado flange set
(Part No. 192693-8)
Dado outer flange
When cutting groove 1/4", 5/16", 3/8", 7/16" or 112".
use this dado outer flange.
Dado hex nut
When cutting groove 1/4", 5/16", 3/8", 7/16" or 1/2",
use this dado hex nut.
Ring
When cutting groove 1/4", 5/16", 318". 7/16" or 1/2",
use this ring.
Washer
When cutting groove 1/4", 5/16" or 318".
use this washer.
19