Cisco ASR 1000 series Hardware Installation Manual page 398

Installing the Cisco ASR 1001 Router in a Rack
Two-Post Rack Installation
The Cisco ASR 1001 Router can be installed on a two-post rack, either 19 inch or 23 inch.
Inner clearance (the width between the inner sides of the two posts or rails) must be at least 19 inches
Note
(48.26 cm). The height of the chassis is 1.71 inches (43.43 mm). Airflow through the chassis is from
front to back.
If you are using a two-post rack secure the rack to the floor surface to prevent tipping and avoid bodily
Caution
injury and component damage.
Position the chassis so the front is closest to you and lift it carefully into the rack. To prevent injury,
Step 1
avoid any sudden twists or moves.
Figure 12-16
Figure 12-16
Slide the chassis into the rack, pushing it back until the brackets meet the mounting strips or posts on
Step 2
both sides of the rack.
Keeping the brackets flush against the posts or mounting strips, align the holes in the brackets with the
Step 3
holes on the rack or mounting strip.
For each bracket, insert and tighten two screws to the rack on both sides.
Step 4
This completes the procedure for installing the chassis on a two-post rack. Proceed to the
Chassis Ground Connection" section on page 12-27
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
12-24
shows the Cisco ASR 1001 Router on a two-post equipment rack.
Cisco ASR 1001 Router Installed on a Two-Post Equipment Rack
Chapter 12 Cisco ASR 1001 Router Overview and Installation
to continue the installation.
"Attaching a
OL-13208-11