Cisco ASR 1000 series Hardware Installation Manual page 151

Chapter 6 Cisco ASR 1006 Router Overview and Installation
Figure 6-9
Figure 6-9
1
Rear rack-mount bracket ear and holes
2
Rear rack-mount bracket
Position the rear rack-mount bracket top hole with the chassis second top hole from the back (See
Step 2
Figure
Insert and tighten the screws on one side.
Step 3
After the bracket is secured to the side of the chassis, slide the two remaining components into the side
Step 4
rack-mount bracket.
Repeat Step 1 through Step 3 on the other side of the chassis. Use all the screws to secure the rear
Step 5
rack-mount brackets to the chassis.
This completes the steps for attaching the rear rack-mount brackets to the Cisco ASR 1006 Router.
Before you mount the Cisco ASR 1006 Router on a rack, make certain you read which rack-mount
Caution
bracket ear holes to use when positioning the chassis in the rack. Installation of the cable-management
bracket is simplified when you use the designated ear holes on the rack-mount bracket. For
cable-management installation instructions, see the
section on page
OL-13208-11
shows where to attach the rear rack-mount brackets to the Cisco ASR 1006 Router.
Attaching the Rear Rack-Mount Brackets to the Cisco ASR 1006 Router
1
0
6-9).
6-18.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
Attaching the Chassis Rack-Mount Brackets
1 2
1
0
3
Rear rack-mount bracket components that
slide into rear bracket attached to the chassis
4
Rear rack-mount bracket screws
"Attaching the Cable-Management Brackets"
3
4
6-13