Makita DHS710 Instruction Manual page 10

WARNING:
For your safety, this tool is equipped with lock-off
•
lever which prevents the tool from unintended
starting. NEVER use the tool if it runs when you
simply pull the switch trigger without pressing the
lock-off lever. Return tool to a MAKITA service
center for proper repairs BEFORE further usage.
NEVER tape down or defeat purpose and function
•
of lock-off lever.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Removing or installing saw blade
CAUTION:
Be sure the blade is installed with teeth pointing
•
up at the front of the tool.
Use only the Makita wrench to install or remove
•
the blade.
1
2
3
014212
To remove the blade, press the shaft lock so that the
blade cannot revolve and use the wrench to loosen the
hex bolt counterclockwise. Then remove the hex bolt,
outer flange and blade.
For tool with the inner flange for other than
15.88 mm hole-diameter saw blade
1 2
3
011230
The inner flange has a certain diameter protrusion on
one side of it and a different diameter protrusion on the
other side. Choose a correct side on which protrusion
fits into the saw blade hole perfectly.
1. Hex wrench
2. Loosen
3. Tighten
4
4. Shaft lock
1. Mounting shaft
5
2. Inner flange
3. Saw blade
4. Outer flange
5. Hex bolt
4
Next, mount the inner flange onto the mounting shaft so that
the correct side of protrusion on the inner flange faces
outward and then place saw blade and outer flange.
BE SURE TO TIGHTEN THE HEX BOLT CLOCKWISE
SECURELY.
CAUTION:
Make sure that the protrusion "a" on the inner
•
flange that is positioned outside fits into the
saw blade hole "a" perfectly. Mounting the blade
on the wrong side can result in the dangerous
vibration.
3
4
014213
When changing blade, make sure to also clean upper
and lower blade guards of accumulated sawdust. Such
efforts do not, however, replace the need to check lower
guard operation before each use.
For tool with the inner flange for a 15.88 mm hole-
diameter saw blade (country specific )
1 2
011231
1 2
014598
Mount the inner flange with its recessed side facing
outward onto the mounting shaft and then place saw
blade (with the ring attached if needed), outer flange
and hex bolt.
BE SURE TO TIGHTEN THE HEX BOLT CLOCKWISE
SECURELY.
10
1. Inner flange
2. Saw blade
3. Outer flange
4. Hex bolt
1
2
1. Mounting shaft
5
2. Inner flange
3. Saw blade
4. Outer flange
5. Hex bolt
4
3
1. Mounting shaft
5
6
2. Inner flange
3. Saw blade
4. Outer flange
5. Hex bolt
6. Ring
4
3