Casio BN-10 Service Manual & Parts List page 36

3 ALARM1
Pressing 2 button, BEEP sound is emitted twice in one second.
Then press ESC button to stop ringing.
4 ALARM2
Pressing 3 button, BEEP sound is emitted three times in one second.
Then press ESC button to stop ringing.
5 CLOCK
Pressing 4 button, the following display appears.
0:00 0X
Then pressing OK button, the following display appears.
12:00 0X
Then pressing ESC button, OTHERS MENU display appears.
6 SW CONDITION
Pressing 5 button, the following display appears.
DETECT MONITOR
BTTERY SW
CARDLOCK SW
LOW BATTERY1
LOW BATTERY2
CRADLE SW
Sliding battery switch and lock switch for MODEM on the back of BN Unit, positions of two upper
asterisks shown above change.
Pressing START button on the cradle after setting it to BN Unit, position of a lower asterisk
shown above changes.
Then pressing ESC button, OTHERS MENU display appears.
7 CS6 DOWN LOAD
The special jig with which data can be written to LSI301 and LSI308 passing through the connec-
tor for MODEM is necessary to perform. This jig can not be prepared.
Therefore, pressing 6 button, the following display appears.
0
CS6 NOTHING
Then pressing ESC button, OTHERS MENU display appears.
OPEN LOCK
ON OFF
— 36 —