How To Insert/Remove A Hx3 Tethered Battery; Insert Hx3 Battery Into Charging Pocket; Remove Hx3 Battery From Charging Pocket - Honeywell HX3 Reference Manual

How to Insert/Remove a HX3 Tethered Battery

Prerequisites:
The steps outlined in
l
The HX3 tethered battery has been removed from the battery sleeve or battery bracket.
l
Note: Do not drop or slam the HX3 battery into the charging pocket. Damage may result.
A fully depleted Standard battery recharges fully in approximately four hours in a powered cradle charging pocket.
l
A fully depleted Extended battery recharges fully in approximately eight hours in a powered cradle charging pocket.
l
The HX3 tether connector must be at the top of the battery in the charging pocket. The battery will not fit properly into the
charging pocket if the tether connector is inserted into the depression of the charging pocket.
Each charging pocket can recharge either battery – standard or extended. The extended battery is noticeably thicker than the
standard battery.
Make sure the battery terminals line up with the charger terminals in the charging pocket.

Insert HX3 Battery into Charging Pocket

Grasp the battery, not the tether, and ensure the battery terminals line up with the charger terminals in the charging pocket.
Slide the battery straight down into the charging pocket until the charging terminals meet.
The charging pocket LED illuminates.
See the section titled Indicators

Remove HX3 Battery from Charging Pocket

Grasp the battery, not the tether, and pull the battery straight up and out of the charging pocket.
The charging pocket LED (B1 or B2) turns off.
Power Cable have been completed and the cradle has a dependable power source.
to determine the status of the B1 or B2 charging pocket LED.
2-13