Hardware Switches - Canon MultiPASS C5000 Service Manual

Hardware Switches

5.1
There is no service hardware switch on the Circuit board.
5.2 Service Data Setting
data can be checked and changed with items on display menus. The default values of
Service
the SSSW/parameters available in this fax machine are shown in this Chapter, 5.2.3 Service
in this manual. The SSSW/parameters given in the previous product-specific
data setting
manual are explained in the G3 Facsimile
model are described in
5.2.1 Service data overview
The service data menu items are divided into the following nine blocks
These setting items are for basic fax service functions such as error management, echo
countermeasures, and communication trouble countermeasures.
These setting items are for functions required during installation, such as NL equahzer
and transmission levels.
These setting items are for inputting numeric parameters such as the various conditions
for the FAX/TEL switching function.
These setting items are for telephone network control functions such as the selection
signal transmission conditions and the detection conditions, for the control signals sent
from the exchange.
The type setting makes the service data conform to a specific country communicatux~s
standards. There is only one setting item in this block.
These setting items are for scanned image processing such as edge enhancement and
error diffusion processing.
These setting items are for basic printer wrvice &nctions such as the reception picture
reduction conditions. Also therr is an item fur resetting the printer section without
switching the power off-on.
this Chapfer, 5.23 Service data setting.
3-31
Chapter 3: Maintenance & Service
The new switches for this