NEC Express5800 series User Manual page 186

8-14 Troubleshooting
Cannot turn the power OFF at the blue screen <Windows 2000>:
→ If you want to turn off the power at the blue screen, execute forced power off
(forced shut down: continue to press POWER switch for 4 seconds). The power
will not be turned off if you press the switch just one time.
The server is not found on the network:
Is the LAN cable connected?
→ Make sure to connect the LAN cable to the network port on the rear of the server.
Also make sure that the LAN cable to use conforms to the network interface
standard.
Is the BIOS configuration correct?
→ The internal LAN controller may be disabled with the BIOS SETUP utility of the
server. Check the setting with the BIOS SETUP utility.
<Menus to check:
[Advanced] - [PCI Configuration] - [Embedded NIC (Dual Gbit)] - [LAN1 Option
ROM Scan], [LAN2 Option ROM Scan]>
Have the protocol and service already been configured?
→ Install the distinctive network driver for the server. Make sure that the protocol,
such as TCP/IP, and services are properly specified.
Is the transfer speed correct?
→ Open the network property dialog box in the control panel to specify the "Link
Speed & Duplex" value to be the same as the value specified for HUB.
During Windows 2000 installation, the following warning is registered in the System Log of
the Event Viewer:
Error detected on the device \Device\CdRom0
during the paging operation.
→ There is no problem on this issue.
The system displays the message below and fails to log in:
→ In Windows Server 2003, the following message will be displayed if you use the
operating system without executing the license authentication.
Select "Yes", and execute the procedure for license authentication.
Windows Product Activation
This copy of Windows must be activated with Microsoft before you can
continue, You cannot log on until you activate Windows.
Do you want to activate Windows now?
To shut down the computer, click Cancel.
YES NO Cancel