Cid (Caller Id) Call Display; Voice First/Tone First - NEC UNIVERGE SV9300 DT410 User Manual

CID (CALLER ID) CALL
DISPLAY
Without answering incoming calls or held calls that
terminate to the Line keys of a terminal, the calling
party's information can be confirmed by the
indications on the LCD.
The feature key is set by system data setting
at initial installation. For details, please
contact the system administrator.
TO DISPLAY CALLING PARTY
INFORMATION
1. Press CID Call Display feature key.
Line key lamp lights red. →
Calling Party information is displayed.
R-TONE MIC
TO REDISPLAY CALLING
PARTY INFORMATION
1. While on a call press CID Call
Display feature key to recall the
Calling Party Information.
Calling Party information is displayed.
201
JAMES SMITH

VOICE FIRST/TONE FIRST

This feature allows incoming calls to your terminal
to either ring or go to voice announcement.
The feature access code/feature key is set by
system data setting at initial installation. For
details, please contact the system
administrator.
TO SET VOICE FIRST/TONE
FIRST MODE
1. Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
2. Dial Voice First/Tone First access
code or press Voice First/Tone First
feature key.
LCD shows current mode.
You will receive a feature dial tone.
VOICE
11:00 AM SUN 1 JUN 2014
Recall
3. Dial any single digit (
Voice First mode is switched to Tone First
mode (or vice versa).
You will receive a feature set tone.
TONE
11:00 AM SUN 1 JUN 2014
Recall
4. Press Speaker key.
Speaker key lamp goes off. →
5. The called party can reply.
56
FEATURE OPERATION
PICK >>>>
- ).
PICK >>>>