Cisco 6500 Series Software Configuration Manual page 461

Chapter 31 Configuring PFC QoS
Enabling PFC QoS Statistics Data Export for a Port
To enable PFC QoS statistics data export for a port, perform this task:
Command
Step 1
Router(config)# interface type
Step 2
Router(config-if)# mls qos statistics-export
Router(config-if)# no mls qos statistics-export
Step 3
Router(config)# end
Step 4
Router# show mls qos statistics-export info
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
This example shows how to enable PFC QoS statistics data export on FastEthernet port 5/24 and verify
the configuration:
Router# configure terminal
Router(config)# interface fastethernet 5/24
Router(config-if)# mls qos statistics-export
Router(config-if)# end
Router# show mls qos statistics-export info
QoS Statistics Data Export Status and Configuration information
---------------------------------------------------------------
Export Status : enabled
Export Interval : 300 seconds
Export Delimiter : |
Export Destination : Not configured
QoS Statistics Data Export is enabled on following ports:
---------------------------------------------------------
FastEthernet5/24
Router#
When enabled on a port, PFC QoS statistics data export contains the following fields, separated by the
delimiter character:
•
•
•
•
•
•
•
78-14099-04
1
slot/port
Export type ("1" for a port)
Slot/port
Number of ingress packets
Number of ingress bytes
Number of egress packets
Number of egress bytes
Time stamp
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
Purpose
Selects the interface to configure.
Enables PFC QoS statistics data export for the port.
Disables PFC QoS statistics data export for the port.
Exits configuration mode.
Verifies the configuration.
Configuring PFC QoS
31-71