Cisco 6500 Series Software Configuration Manual page 298

Displaying IPX MLS Information
Displaying IPX MLS Cache Entries for a Specific Destination Address
To display IPX MLS cache entries for a specific destination IPX address, perform this task:
Command
Router# show mls ipx [destination ipx_addr]
This example shows how to display IPX MLS entries for a specific destination address:
Router# show mls ipx destination 1.2.2.2
DstNet-DstNode
-----------------------------------------------------------------------
SrcDstPorts
----------------------------------------
Number of Entries Found = 0
Router#
Displaying IPX MLS Cache Entries for a Specific Source Address
To display IPX MLS cache entries for a specific source network address, perform this task:
Command
Router# show mls ipx source ipx_address
This task should be performed with IPX flow in destination-source mode. For more information, see the
Note
"Flow Mask Modes" section on page
This example shows how to display IPX MLS entries for a specific source IPX address:
Router# show mls ipx source 1.2.2.2
DstNet-DstNode
-----------------------------------------------------------------------
SrcDstPorts
----------------------------------------
Number of Entries Found = 0
Router#
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
20-10
Chapter 20
SrcNet DstVlan-DstMac
SrcDstEncap Age LastSeen
20-3.
SrcNet DstVlan-DstMac
SrcDstEncap Age LastSeen
Configuring IPX Unicast Layer 3 Switching on Supervisor Engine 1
Purpose
Displays IPX MLS entries for a specific
destination address (net_address.node_address).
Pkts Bytes
Purpose
Displays IPX MLS entries for a specific source
network address (net_address).
Pkts Bytes
78-14099-04