Maintenance - Makita 6833 Instruction Manual

1
15mm
1. Wall
2. Stopper base

MAINTENANCE

1. Limit mark
1. Screwdriver
2. Brush holder cap
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The
use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita service center.
• Phillips bit
• Drywall screw strips
Driving in corner
004186
This tool can be used to drive at a position 15 mm away from the wall as
shown in the figure.
2
CAUTION:
• Driving at a position closer than 15 mm to the wall or driving with the
stopper base in contact with the wall may damage the screw heads and
cause wear on the bit. This may also lead to poor fastening of screws
and malfunction of the tool.
CAUTION:
• Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace when they wear
down to the limit mark. Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the same time. Use only
identical carbon brushes.
1
Use a screwdriver to remove the brush holder caps. Take out the worn carbon
002686
brushes, insert the new ones and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any other mainte-
nance or adjustment should be performed by Makita Authorized Service Cent-
ers, always using Makita replacement parts.
1
2
• Extension handle
• Plastic carrying case
9