ASSEMBLY
1
2
1. Casing
2. Thumb screw
1 2
3
1. Dust cover
2. Plane bearing
3. Bit
1
1. Lever
2. Stopper base
3. Plate
4. Casing
6
CAUTION:
•
Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Installing or removing the bit
Loosen the thumb screws which secure the casing. Pull out the casing in the
002656
direction of the arrow.
Press the dust cover toward the plain bearing and pull out the bit. If the dust
002657
cover cannot be moved as far as the plain bearing, try it again after turning the
bit slightly.
To install the bit, insert it into the socket while turning it slightly. After installing,
always make sure that the bit is securely held in place by trying to pull it out.
Setting for desired screw length
002663
There are 3 (for Model 6833 & 6836) or 5 (for Model 6834) positive-lock screw
length settings. To obtain the desired setting, pull out the stopper base while
depressing the lever until you see the number of the desired screw length
2
(indicated on the plate) appear to rest on the very top edge of the casing. See
the table below for the relation between the number indicated on the plate and
the respective screw length ranges.
3
4
Number indicated on the plate
(Note) * for Model 6834 only
25/28
32
40
* 51
* 57
Screw length range
25 mm - 28 mm
28 mm - 35 mm
35 mm - 41 mm
41 mm - 51 mm
51 mm - 57 mm
006404