Figure 3-15 Adding A Route; Table 3-8 Parameter Of An Iscsi Host Port - Huawei OceanStor S5600 Initial Configuration Manual

3 Configuring the Storage System

Table 3-8 Parameter of an iSCSI host port

Parameter
IP Address
Subnet Mask
Storage devices can be accessed by the AS that is not in the same network segment as themselves.
If the IP address of the NIC port on the AS is in a different subnet from the IP address of the
iSCSI host port on the controller, go to
go to
Step 4 Click Add Route. The interface is displayed. See

Figure 3-15 Adding a Route

Step 5 Set the parameters for adding a route based on the actual networking
describes the parameters for adding a route.
3-24
Description
This parameter indicates the IP address of the iSCSI host port on a
controller. When setting this parameter, note that:
l
l
NOTE
This parameter indicates the subnet mask of the IP address of the
iSCSI host port.
CAUTION
Step 6.
NOTE
In Figure 3-15, select a route and then click Delete Route. The route is deleted.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Each field of the IP address cannot be null. In addition, each field
must be an integer.
The value of the first field ranges from 1 to 223 and the values of
the other fields range from 0 to 255.
Avoid using special IP address such as broadcast IP address, gateway IP
address, and so on.
Step 4; if the two IP addresses are in the same subnet,
OceanStor S5600 Storage System
Initial Configuration Guide
Figure 3-15.
environment.Table 3-9
Issue 02 (2009-09-30)