Controlling The Far End Camera - Cisco TelePresence C20 Administrator's Manual

Cisco TelePresence System Quick Set C20 and Profiles using C20
Contents

Controlling the far end camera

While in a call, you can control the remote participant's
camera (far end) provided that:
• The Remote Monitoring option is installed on your video
system (software version TC7.3.3 and later).
• The Video AllowWebSnapshots setting is switched On
(software versions TC7.3.0 to TC7.3.2).
• Far end camera control (FECC) is enabled on the far end
system. Only the available controls will appear.
Whether or not snapshots of input sources are shown as illustrated,
depends on the software version, configuration, and options installed
on the video system. Refer to the About snapshots and remote
monitoring sections (► TC7.3.3 or newer or
D14637.17 Profile C20 and Quick Set C20 Administrator Guide TC7.3, JULY 2015.
Introduction Web interface Web interface
Navigate to: Call Control
Control the remote participant's camera
1. Click the camera icon to open the
remote camera control window.
2. Use the left and right arrows to pan the
camera; the up and down arrows to tilt
it; and
For software versions TC7.3.0 to
TC7.3.2, the cursor must be in the
image to show the controls.
► TC7.3.0 to TC7.3.2).
System settings
+ and - to zoom in and out.
21
Setting passwords
www.cisco.com — Copyright © 2010-2015 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices