Video Input Source [1..2] Optimaldefinition Threshold60Fps; Video Mainvideosource; Video Layout Disabledisconnectedlocaloutputs - Cisco TelePresence C20 Administrator's Manual

Cisco TelePresence System Quick Set C20 and Profiles using C20
Contents

Video Input Source [1..2] OptimalDefinition Threshold60fps

For each video input, this setting tells the system the lowest resolution where it should transmit
60fps. So for all resolutions lower than this, the maximum transmitted frame rate would be
30fps, while above this resolution 60fps would also be possible, if the available bandwidth is
adequate.
Requires user role: ADMIN
Value space: <512_288/768_448/1024_576/1280_720/1920_1080/Never>
512_288: Set the threshold to 512x288.
768_448: Set the threshold to 768x448.
1024_576: Set the threshold to 1024x576.
1280_720: Set the threshold to 1280x720.
1920_1080: Set the threshold to 1920x1080.
Never: Do not set a threshold for transmitting 60fps.
Video Input Source 1 OptimalDefinition Threshold60fps: 1280 _ 720
Example:
Video Input Source [1..2] Quality
When encoding and transmitting video there will be a trade-off between high resolution and
high frame rate. For some video sources it is more important to transmit high frame rate than
high resolution and vice versa. The Quality setting specifies whether to give priority to high
frame rate or to high resolution for a given source.
Requires user role: ADMIN
Value space: <Motion/Sharpness>
Motion: Gives the highest possible frame rate. Used when there is a need for higher frame
rates, typically when a large number of participants are present or when there is a lot of
motion in the picture.
Sharpness: Gives the highest possible resolution. Used when you want the highest quality of
detailed images and graphics.
Video Input Source 1 Quality: Motion
Example:
D14637.17 Profile C20 and Quick Set C20 Administrator Guide TC7.3, JULY 2015.
Introduction Web interface System settings System settings

Video MainVideoSource

Define which video input source shall be used as the main video source. The video input source
is configured with the "Video Input Source [1..n] Connector" setting.
Requires user role: USER
Value space: <1/2>
Range: Select the source to be used as the main video source.
Video MainVideoSource: 1
Example:

Video Layout DisableDisconnectedLocalOutputs

Determine whether or not the built-in layout engine shall set layouts on local outputs that have
no monitor connected.
Requires user role: ADMIN
Value space: <Off/On>
Off: The built-in layout engine sets layout on all local outputs, also the ones not having any
monitor connected.
On: The built-in layout engine does only set layout on local outputs having a monitor
connected.
Video Layout DisableDisconnectedLocalOutputs: Off
Example:
www.cisco.com — Copyright © 2010-2015 Cisco Systems, Inc. All rights reserved.
111
Administrator Guide
Setting passwords Appendices