Installing Dust Bag - Makita CL104D Instruction Manual

ASSEMBLY
Disposing of Dust
CAUTION:
Empty the cleaner before it becomes too full, or
•
the suction force weakens.
Be sure to empty out the dust inside the cleaner
•
itself. Failure to do so may cause the sponge filter
to be clogged or the motor to be damaged.
Never throw away the dust stopper because it
•
should be used whenever either the dust bag or
the dust pack is used.
1. Push the button to open the front cover. Opening it until
a click is heard allows a positive stop at that position.
1
2
014730
CAUTION:
When closing the front cover, be careful not to
•
pinch your fingers.
014731
NOTE:
The front cover comes off when trying to open the
•
front cover more than 90°. If the front cover comes
off, install it into the front cover joint in place.
2. Pull out both the orange-colored dust stopper and
dust bag together at the same time.
1
014732
1. Front cover
2. Button
1. Front cover
1
2. Front cover joint
2
1. Dust stopper
3. Remove the dust stopper and empty the cleaner.
1
008920
008921
Dust bag and paper pack
Install either dust bag or paper pack before using cleaner.
Use the dust stopper when installing either dust bag or paper
pack.
Dust bag are usable many times repeatedly by cleaning it out.
Paper pack is a throw-away type. Throw away the entire
paper pack without emptying when it has become full.

Installing dust bag

1
2
008930
Use the dust stopper when installing dust bag. Be
careful not to take the upper side for the lower side by
mistake because they are different each other.
1. Insert the protrusion of the dust bag into the
groove in the dust stopper as shown in the figure.
1
2
008935
5
1. Dust stopper
1. Upper side of
dust stopper
2. Lower side of
dust stopper
1. Dust stopper
2. Groove
3
3. Dust bag