Assembly - Makita LS0815F Instruction Manual

1
014271
CAUTION:
Never look into the laser beam. Direct laser beam
•
may injure your eyes.
LASER RADIATION, DO NOT STARE INTO THE
•
BEAM OR VIEW DIRECTLY WITH OPTICAL
INSTRUMENTS, CLASS 2M LASER PRODUCT.
Before shifting the laser line or performing
•
maintenance adjustment, be sure to unplug the tool.
To turn on the laser beam, press the upper position
(ON) of the switch. To turn off the laser beam, press the
lower position (OFF) of the switch.
Laser line can be shifted to either the left or right side of
the saw blade by loosening the screw holding the laser
unit box and shifting it in the desired direction. After
shifting, be sure to tighten the screw.
1
1. Screw holding the laser unit box
014275
Laser line is factory adjusted so that it is positioned within
1 mm from the side surface of the blade (cutting position).
NOTE:
When laser line appears dim and hard to see
•
because of direct sunlight, relocate the work area
to a place where there is less direct sunlight.
Cleaning of the lens for the laser light
If the lens for the laser light becomes dirty, or sawdust
adheres to it in such a way that the laser line is no longer
easily visible, unplug the saw and remove and clean the lens
for the laser light carefully with a damp, soft cloth. Do not use
solvents or any petroleum-based cleaners on the lens.
1. Switch for laser
10
NOTE:
When laser line is dim and almost or entirely
•
invisible because of the direct sunlight in the
indoor or outdoor window-by work, relocate the
work area to a place not exposed to the direct
sunlight.
Light action
1
014270
1
014274
To turn on the light, press the upper position (ON) of the
switch. To turn off the light, press the lower position
(OFF) of the switch.
CAUTION:
Do not look in the light or see the source of light
•
directly.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it
•
may to lower the luminance.

ASSEMBLY

WARNING:
Always be sure that the tool is switched off
•
and unplugged before working on the tool.
Failure to switch off and unplug the tool may result
in serious personal injury.
1. Light
1. Switch for light