Makita 5007F Technical Information page 5

R
epair
( 4 ) Assemble safety cover by holding with retaining ring S-42.
Assemble tension spring 4. (Hitch the end of tension spring on safety cover, and another end on blade case.)
Assemble rubber sleeve to blade case by screwing it with pan head screw M6 x 20.
Motor side
Fig. 5
< 3 > Replacing armature and light unit (LED)
( 1 ) After disassembling safety cover, take off brush holder caps and carbon brushes as illustrated in Fig. 6.
And then take off 4 pcs. of countersunk head screws M5 x 12 which are screwed into base plate from its bottom
side for fastening angular guide. See Fig. 6 A.
Brush holder cap
Carbon brush
Rubber sleeve 6
Pan head screw
M6 x 20
Blade installing
side
Angular guide
Fig. 6
Motor side
Tension spring 4
Retaining
ring S-42
Safety cover
Wrong assembling
to safety cover
* The tension spring 4 comes to
the blade installing side and interferes
with movement of the safety cover.
Bottom view of p base plate
< Note in assembling >
Blade installing
side
Torsion spring
comes to the
space between
safety cover and
bearing box.
Correct assembling
to safety cover
Blade installing
Motor side
side
Do not touch
this screw.
4 pcs. of counter sunk head
screws M5 x 12
Fig. 6 A
P 5 / 12