Operation - Makita 3601B Instruction Manual

For tool with lock-off button
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, depress the lock-off button and pull the
switch trigger. Release the switch trigger to stop.
008506
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing the bit
005042
CAUTION:
Install the bit securely. Always use only the
•
wrenches provided with the tool. A loose or
overtightened bit can be dangerous.
Do not tighten the collet chuck without inserting a
•
bit or install smaller shank bits without using a
collet sleeve. Either can lead to breakage of the
collet chuck.
Insert the bit all the way into the collet chuck and
withdraw it very slightly (approx. 2 mm). Then tighten the
collet chuck securely with the two wrenches. When
using smaller shank bits, first insert the appropriate
collet sleeve into the collet chuck, then install the bit as
mentioned above.
To remove the bit, follow the installation procedure in
reverse.
1. Lock-off button
1
2. Switch trigger
2

OPERATION

Set the tool base on the workpiece to be cut without the
bit making any contact. Then turn the tool on and wait
until the bit attains full speed. Move the tool forward over
the workpiece surface, keeping the tool base flush and
advancing smoothly until the cutting is complete.
When doing edge cutting, the workpiece surface should
be on the left side of the bit in the feed direction.
1
2
3
1. Workpiece
2. Bit revolving direction
3. View from the top of the tool
4. Feed direction
001984
NOTE:
Moving the tool forward too fast may cause a poor
•
quality of cut, or damage to the bit or motor.
Moving the tool forward too slowly may burn and
mar the cut. The proper feed rate will depend on
the bit size, the kind of workpiece and depth of cut.
Before beginning the cut on the actual workpiece, it
is advisable to make a sample cut on a piece of
scrap lumber. This will show exactly how the cut
will look as well as enable you to check
dimensions.
When using the straight guide or the trimmer guide,
•
be sure to install it on the right side in the feed
direction. This will help to keep it flush with the side
of the workpiece.
2
1
001985
5
2
4
4
1. Feed direction
3
2. Bit revolving
direction
3. Workpiece
4. Straight guide
4