Rear Chassis With Mudguard And Air Box Removal (Tc); Rear Chassis With Mudguard And Air Box Removal (Te-Txc) - Husqvarna 2013 TC 250R Workshop Manual

TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA
1
2
4
5
2
1
GENERAL PROCEDURES

Rear chassis with mudguard and air box removal (TC)

- Remove the saddle as described in the relevant paragraph.
- Remove the side panels as described in the relevant paragraph.
- Lift the tank at the rear end.
- Disconnect the air temperature sensor (1).
- Remove the exhaust silencer as described in the relevant para-
graph.
- Slacken clamp (2) that secures the rubber coupling of the air box (3) to the
H10003
throttle body.
3
- Remove the upper fixing (4) and lower fixings (5) on both sides of the rear
chassis using a 10 mm ring wrench.
- Pull the rear chassis (6) rearwards together with mudguard and air box, and
detach it from the main chassis.
H10004

Rear chassis with mudguard and air box removal (TE-TXC)

- Remove the following parts in the order given: saddle, side panels, fuel tank,
silencer and battery (see relevant paragraphs for instructions).
- Shear the plastic clips securing wiring to rear chassis.
6
H10005
- Disconnect the connector (1) of the turning indicator relay (2) (TE).
- Remove the solenoid starter (3) from its mount.
H00633
E.5
Workshop Manual Ed. 07-2012