Engine Water Temperature Connector; Lambda Sensor Position And Connector; Ignition Cable Connection; Chassis Cable Holes And Connection To Tail Light, Flasher Starter Relay - Husqvarna 2013 TC 250R Workshop Manual

TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
20
22
H11472
24
26
Workshop Manual Ed. 07-2012
ELECTRICAL SYSTEM
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA

• Engine water temperature connector

Connect the engine water temperature connector (20) to the thermostat.
H11471

• Lambda sensor position and connector

Tighten the Lambda sensor (21) in the corresponding seat.
Connect the Lambda sensor connector (22) as shown.
21
H11445

• Ignition cable connection

23
Connect the ignition connectors (23) as shown.

• Chassis cable holes and connection to tail light, flasher starter relay

Route the rear end of the wiring (24) as shown in the figure.
Connect the tail light/turning indicators connector (25) (TE).
-
-
27
H11473
25
H11474
Connect the connector (26) to the flasher (TE).
Connect the connector (27) to the solenoid starter.
M.50