Slot Control - NEC Xen Topaz Programming Manual

IN
SA
SB
Description
Use Program 90-05 : Slot Control to close (turn off) or delete (uninstall) circuit boards (slots 1-18).
Delete allows you to completely uninstall the PCB. You might want to do this if you want to remove a PCB
and plug it into a different slot - and still retain the port assignments. If a different type of interface card is
being installed into a slot previously used (example; changing from a BRIU to VOIPU PCB), the slot should
be deleted (Menu 1) first before installing the new interface card.
Reset allows you to send a reset code.
Input Data
Menu Number
Conditions
When you delete or reset a PCB, you must first remove it from its slot then run Program 90-05.
When reusing the slot for another PCB, you must plug the PCB in or reset the system before the system
will use the slot again.
Feature Cross Reference
None
Telephone Programming Instructions
To enter data for Program 90-05 (Slot Control):
1. Enter the programming mode.
2. Enter 90 05
90-05-01 Menu 1
Slot Number
3. Enter the number of the item you want to program.
90-05-xx Menux
xxxxx
4. Select the Menu number to be programmed by pressing the FLASH or the VOLUME▲ or VOLUME▼
keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you've exited that series' programming section.
Xen Topaz Programming Manual
P
ROGRAM
Slot Number
1-18 (0 : No Setting)
312
Program 40 to 92
90: M
AINTENANCE
90-05: S
LOT
1 : Delete
2 : Reset
P
ROGRAM
C
ONTROL